|
H15A - Digital Telemetry Basic PTFZ
The H15A is a compact 12Vdc digital telemetry control system for pan & tilt and motorized lenses. It is designed to complement the H2001 and the H2002 mini P&T units and compact motorized zoom lenses. It has 8 push buttons for simple radio operation of PTFZ and a 16 channel internal switch. There is FSK data input from a radio earphone socket or balanced cable pair. There is a dual intensity led for power and data transmission along with robust XLR connectors. There are also dual FSK data outputs for balanced cable pair and standard voice grade radios with PTT (walkie-talkies). Internal speed control selection for either 5V or 12V to either P&T or lens motors. Direct connection to P&T and motorized zoom lenses.
|
|
|
|
H17 - IP & Telemetry Control for PTFZ
The H17 telemetry camera control system uses FSK voice grade (radio link) and RS232 to control multiplePTFZ units. Features: 12Vdc focus, Zoom & Iris operation, Multi-channel, both FSK and multiple simultaneous functions, IP control, rugged diecast metal housing.
|
H17CMB - IP Telemetry System
The H17CMB is an IP telemetry system for the remote control of P&T, as well as Sony Block and Dome cameras over a LAN, WLAN, or ADSL connection. The automatic-connect feature between the built-in Bosch VIP 1000 encoder and decoder makes the H17-B system a complete plug and play IP solution. The H17B allows video transmission in mpeg4 compressions, data for the control of P&Ts and Sony Block or Dome cameras as well as optional bi-directional mono audio. The video is able to be viewed on the control monitor and also as an analogue output for recording via the BNC connector. There are 4 preset memory positions for fast recall of PTFZ positions and 3 dry contact relay outputs for external switching. Using a PC for setup and monitoring, there is also the ability to switch on the Motion Detection system and relay input triggers to automatically connect to a predetermined IP address and send the video signal from the encoder.
|
|
Hand Held PTFZ Controllers
The H20HHC is a hand held local control for PTFZ. Powered by a PP3 9V battery, it will drive the H2001, H2002, H2003, and H2004 P&T units and motorized zoom lenses over cable to a distance of about 200 feet. A potentiometer allows speed control for the motors. The H20HHC can be used in non-telemetry situations or as a set up tool to check operation prior to telemetry connection. It has two identical output sockets for P&T and lens control. The H20HHCS controls P&T as well as the modified Sony 480/780 camera modules. The H20SD is the same as the H20HHCS, but it is housed in a diecast metal box, making it "heavy duty".
|
|
|
| H20SD H/Held Controller
The H20SD hand held controllers are designed to be used with HarrisTech P&T units, Sony block cameras, or any conventional motorized zoom lenses. The H20SD are housed in black powder coated diecast metal boxes and the functions are accessed and controlled through paddle switches and a speed control potentiometer. The XLR version has XLR connectors for a P&T, lens and 12Vdc. An alternative, H20SD-XLR-B, has a 9V battery compartment instead of the 12VDC XLR socket. The MIL version has an XLR connector for 12VDC, while the MIL-C connector runs P&T and the camera functions. It also has a BNC for video output.
|
H20SDM - H/Held Controller
The H20SDM hand held controllers are designed to be used with HarrisTech P&T units, Sony block cameras or any convention motorized zoom lenses. The H20SDM are housed in black powder coated diecast metal boxes with the functions accessed and controlled through paddle switches, a speed control potentiometer and five auxiliary switches with screw terminals. It also has a 5.6" TFT video monitor with a BNC video out.
|
|
|
| H21 - Microphone Pre Amplifier
The H21 is a general purpose microphone pre amplifier with a maximum gain of 60dB, distortion of <0.1% and a maximum output level of -2dBm through a balanced 600Ω transformer. A solder link on the PCB will activate the low cut filter. Higher load impedances will lift the high frequency response. The device is regulated to 6VDC and the performance specifications can be achieved with a supply voltage between 8.5V and 18V. It will operate down to 6.5V, but with reduced dynamic range. Quiescent current it ≈ 10mA. With a Knowles insert connected, and the gain potentiometer set to maximum, they dynamic range is around 35dB and ould be suitable for more distant sounds. With the gain potentiometer set to just above minimum, which would be suitable for most situations, the dynamic range is around 70dB. The actual amplifier noise floor is around 10dB lower without filters. The microphone bias voltage is set to 1.1V to be compatible with all the Knowles microphones, includingthe new FG3329 miniature cylindrical model, which has a maximum bias voltage of 1.6V.
|
|
H22 - PTFZ Controller for Internet and DTMF
HarrisTech's H22 "Pan Tilt Focus Zoom" controller unit utilizes either DTMF tones or Sony VISCA RS232 to cotnrol P&T, auxiliary switches, and Sony Block camera functions. The 12 standard DTMF tones at earphone level will drive 12VDC P&T units, operate one latching and two momentary dry contact relay switches and control Sony Block cameras for Focus, Zoom, Auto Focus, Night Shot, Auto Night Shot, Shutter Speed, Back Light, and Mirror Image.
|
|
|
|
H305 - Audio Pre-Amplifier
HarrisTech's H305 Audio Pre-amplifier unit is ideally suited for portable field work due to its small size, though the robust casing allows for a safe permanent install as well. Power for these pre-amps is via an internal 9V battery OR an external 12VDC supply.
|
|
H2001WHV - Weatherproof P&T
The H2001 is a P&T with direct Sony VISCA serial data drive. It can be used with existing H22 family of controllers for additional DTMF control and aux switches. It can also be used with new HarrisTech H17RV-B telemetry system with built in Bosch VIPX IP video cards. It has seamless IP operation over LAN, WLAN, and ADSL. It has an optional four or six preset PTFZ memories built in to the H2001WHV-P.
|
|
|
|
H2001 - P&T Unit
The compact and hardy H2001 P&T unit offers precision controlling for cameras, IR lights, small antennas or any balanced load up to 1kg. Belt driven from two high quality Swiss 12VDC gear motors, the H2001 has a maximum P&T angulations of 270° at 15°/second (maximum) with adjustable internal limit switches and only draws a tiny ?10mA to 30mA. Made from black Delron acetal and powder coated aluminum, the H2001 will not rust.
|
H2002 Mini Front Pivot P&T Unit
The H2002 is HarrisTech's miniature front pivot P&T unit for operation on 12VDC systems drawing ~ 10mA. It is suitable to move the weight of lipstick cameras with lenses and moves at around 6°/second at 12VDC. Pan: +/-45°, Tilt Up: 15°, Tilt Down 40°.
|
|
|
|
H2004 - Front Pivot Micro Pan Unit
The H2004 is a HarrisTech designed and manufactured miniature front pivot pan unit for operation on 12VDC systems. It is suitable for board or cylinder cameras with pinhole lenses as well as small conventional cameras upto 300g. The optical pivot point is 5mm forward of the front face of the device, which will allow an additional 50° of horizontal field of view through a very small hole in the covert hide.
|
|
H2005 - Pericam
The H2005 is capable of an amazing 400° pan view and a tilt range of 20° up and 40° down. Don't hesitate to leave the H2005 outdoors in any weather thanks to the presurized and fully weatherproof housing. Concealing the Sony 480/980, this cylindrical weatherproof Pericam, made from black anodized aluminum, has been designed and built by HarrisTech. It is easy to hide in such places as light bollards, vent pipes, and car seat head-rests thanks to the application of atelescope mirror allowing the camera to sit upright in a confined space without compromising viewing angle.
|
|
|
| H2005Y - Custom Periscope PTFZ Camera
The H2005Y contains a Yamano/Rainboy 8-154mm IR corrected motorized zoom lens or a 15-300mm motorized zoom lens. The P&T spcification is identical to the H2005. The center section is 4" diameter.
|
H2008 - Front Pivot P&T Unit for PTZ Cameras
The H2008 is HarrisTech's Frotn Pivot P&T unit designed specifically for Zoom cameras. Pan: +/-30°, Tilt Up 20°, Tilt Down 25°.
|
|
|
|
H2020 - P&T Unit
The H2020 is a weatherproof medium duty P&T unit for operation on 12VDC systems. Pan: 360°, Tilt 330°.
|
|
